Как мультиметром (DT-830B) определить где фаза, а где 0 ? , Измерения Опции

[Александр_Т]

Есть у меня китайский мультиметр DT-830B, вот не могу понять можно ли им определить где фаза, а где 0 в 2х-жильной проводке(~220V).
Про индикатор знаю и как определить используя "землю" тоже знаю. Интересует именно способ определить "на месте" без третьих проводов и предметов.

[Гость_Гость_*]

Вот его сообщения с форума:
The actual cause of the arc was that i was using the wrong meter for the job. I was using a motor rotation meter instead of a phase rotation meter. A motor rotation meter is not meant to be used on live circuits. I had actually been using that meter for months on live circuits with no problem... BUT, Regardless of how the accident started (and i am in no way excusing my actions), if i had been wearing my PPE, i would have simply gone to the hospital for a check up with maybe some shrapnel and minor burns.

No. I had actually just finished hooking up a giant portable generator to a frozen foods warehouse. I had already checked the phase rotation (with the same meter) on the generator, and was checking the phase rotation on the switch gear when the meter failed.

well kind of. The meter failing blew a 'puff' of carbon into the I-Line buss bars as i connected the third lead, which is the equivelent of throwing a cup of water into it. this created an arc between the three phases which created the arc flash explosion. it literally blew a 1' hole through 6,000 amp/ 480 volt switch gear.

Может кто переведет?